The KOR-Mobile systems can be used for trailer-mounted drill and/or remote drilling from the trailer, depending on your application needs.
Get the job done faster and reduce job costs.

• Quick set up and tear down
• Drill faster with gasoline motors (6.5 and 15 HP)
  • Drills 3-4 times faster than electric drill machines
• Minimize lane closure/traffic control requirements
• Increased bit life with very stable drilling platform
• Easy removal from vehicle when not in use

• Gain independence in the field with gasoline or hydraulic powered, trailer mounted drilling system Stand-alone system, no additional power supplies required Power environments available: 15 HP gasoline or 21-to-64 HP hydraulic drill systems 200-gallon polyethylene horizontal water tank system Stable drilling platform provided by full-size trailer

  KOR-Mobile System

  Obtain years of use and dependable performance

• Heavy-duty, dual-precision ground columns and tenzalloy, precision machined carriage assembly
• Smooth-precision ball feed screw system
• Capable of handling large and small hole drilling
• Heavy-duty dual column and carriage assembly for large holes

Flexible drilling system

• Easy removal of drill machine from trailer platform for non-trailer drilling (gasoline systems)
• Accurate hole drilling positioning, easy alignment of drill platform
• From 16" to 72" diameter core bit capacity and 24" to 60" column travel

K-150 Standard Package Includes:

• Gasoline powered core drill system includes:
  • 15 HP, 4 cycle, electric start motor
  • Variable RPM: 300 to 1100 Bit RPM
  • 16 amp charging system
  • 16-inch bit diameter capacity
  • 24-inch carriage travel
• 82"-wide full size, single axle, steel construction trailer
  • 60" x 96" steel bed, 132" x 82" outside dimension
  • 3450 lbs. rated, dual rear levelers for drilling stability
  • Adjustable tongue jack and caster
  • Electric brake system for safe towing
  • Running and brake lights pre-wired
  • 4-wire electrical connection to interface with towing vehicle
  • License plate holder
  • 195R15 tires
• 200-gallon water system
  • 12 VDC water pump
  • Demand 2 GPM
  • 12 volt group 65 battery provides power for water pump
  • Electrical on/off switch
• Manufactured to CSDA standards

K-150-G624

K-160 KOR-Mobile System Includes:

Drill Head Variable Position System to locate bit position fore and aft approximately 12 inches, left and right approximately 43 inches, a lockable weather resistant toolbox, and a hydraulic assisted machine lift plus all the features of the K-150

K-160-G616 System Includes:

All the features of both the K-150 and K-160 plus 8-inch auger capabilities.

K-160-G624